Cuprinol Garden Furniture Restorer
Restores grey, weathered wood to its original colour
Your Measurements:
Amount Needed:
For the best result we recommend to use
{coatAmount} for {productTitle}
-
Coverage A 1L tub is normally sufficient for 8m2 in 2 coats.Coverage can vary depending on application method and the condition and nature of the surface
-
Drying Time 16 hours. Allow to dry thoroughly before applying a protective finish.
-
Coats 2
-
Long lasting
Product Description
Cuprinol Garden Furniture Restorer is an easy to use gel that removes the grey, weathered surface wood to reveal the golden timber below. Simply brush on, scrub if needed, leave for 15 minutes and rinse off.
Application Description
Stir thoroughly before use. Wearing suitable protective gloves, apply liberally with a paint brush. The wood will start to lighten in colour. Immediately after application, work into the surface of the wood using a mild abrasive scrubbing pad or stiff bristle brush. Leave to stand until no further lightening occurs, but for no more than 15 minutes. Work manageable areas at a time so that application, abrasion and washing off can be completed within 15 minutes. Wash off with plenty of water using a watering can or hose. Do not use a high pressure washer. Allow the furniture to dry thoroughly before use. In cases of severe weathering a further coat may be necessary to fully restore the colour. If necessary, sand the wood to remove loose fibres and give a smooth base before finishing with an appropriate oil or stain. Do not apply in temperatures below 5C or if rain is likely before the job is complete.Protect any areas underneath the garden furniture being restored. Cuprinol Garden Furniture Restorer should not be allowed to come into contact with grass or plants as it may cause browning or die-back. When washing off, avoid splashing onto plants or grass. If this occurs, dilute splashes with copious amounts of water.
Health & Safety
Tips & Advice
-
1. Preparing the SurfacesRemove excessive dirt and soiling, large areas of algae, lichen, fungi or moss with a scraper or stiff brush. Only suitable for use on bare or previously oiled wood.
-
2. After useRemove as much restorer as possible from brushes before cleaning with water. Clean up any spills while still wet.
-
3. StoringDo not use or store in extremes of temperature or wet conditions
How much paint do I need?
More than one wall to paint? Try our advanced paint calculator
Measure the height and length of the surface you want to paint (in metres or centimetres).
Your Measurements:
{{!-- This value will be injected with JavaScript --}}
Amount needed:
{{!-- This value will be injected with JavaScript --}}
Actual coverage will depend on the conditions of the surface. If the colour change is strong, more coats may be required.
More than one wall to paint? Try our advanced paint calculator