Usage guide

Cuprinol TimberCare has been specially formulated to colour and protect rough sawn garden timber in just one coat. Its special pigments ensure rich colour and even coverage every time. Cuprinol TimberCare is quick drying, low odour and safe to use around plants and pets.

TimberCare is formulated for exterior use on rough sawn garden wood including fences, sheds, gates and trellis. It may be applied over wood that has been previously pressure treated, or treated with creosote provided it has been allowed to weather. TimberCare is not recommended for use on smooth or planed wood, decking or garden furniture.

A 5L tub is normally sufficient for: 30m² with 1 coat, or 8 fence panel sides (6' x 6')
Coverage can vary depending on the condition and nature of the surface.

Surfaces should be dry and free from dirt, algae, lichen, fungi or moss.

STIR THOROUGHLY BEFORE AND DURING USE. Cuprinol TimberCare is not suitable for Spray application. Try a test area first to ensure that colour and adhesion are acceptable. Please note that the colour in the tub may be different to the final shade when dry. Brush on evenly along the grain. Do not apply in temperatures below 5°C, in damp conditions or if rain is likely before the product has dried.

TimberCare will be touch dry in 2-4 hours under normal weather conditions. One coat is normally sufficient but a second coat can be applied for a deeper colour or added protection. Ensure first coat is fully dry before applying subsequent coat.

Reseal tub after use. Clean up any spills while still wet. After use remove as much product as possible from brushes/equipment before cleaning with water. Do not store or use in extremes of temperature and protect from frost.

Always read the pack instructions carefully before use.