Usage guide

Cuprinol Stay New Decking is a truly invisible matt finish that keeps decking “looking like new". With its unique wax enriched formulation and added UVA absorbers, Cuprinol Stay New Decking provides ultimate protection from the damaging effects of sunlight, rain and other weathering for up to 3 years.

Cuprinol Stay New Decking can be used on new or restored decking to lock in the "like new" look.

In areas of heavy traffic more regular retreatment may be necessary.

Cuprinol Stay New Decking can be used on new or restored decking to lock in the “like new” look. New, pre-treated decking often has a green tint which may take up to 3-4 months to naturally fade under Cuprinol Stay New Decking.

A 2L tin is normally sufficient for: 18m² with 3 coats.
Absorbent or weathered wood may need more coats.

Surfaces should be clean, dry and free from algae and mould. For best results brush to remove dirt and debris and clean the surface with Cuprinol Decking Cleaner. Rinse well and allow to dry.
Bare wood: Brush to remove dust and debris. Clean off any dirt, mould or algae using Cuprinol Decking Cleaner. Rinse off with water and allow to dry before applying Cuprinol Stay New Decking.
Pre-sealed wood: Decking previously treated with Cuprinol Decking Oil, Decking Seal or similar penetrating treatments should be allowed to weather for at least 3 months before applying Cuprinol Stay New Decking. Before application clean surfaces as for bare wood.
Weathered wood: Use Cuprinol Decking Restorer to bring back the natural colour of the wood following on-pack instructions for this product.
Painted or varnished wood: Sand off or chemically strip existing coatings then treat as new bare wood.

Stir well before and occasionally during use. Using a synthetic bristle brush, apply 2-3 coats (3 coats are recommended for best results and up to 3 years performance.) Do not apply in direct sunlight, in temperatures below 5°C, in damp conditions or if rain is likely before the product has dried.

Cuprinol Stay New Decking will normally be touch dry in 1-2 hours in good drying conditions. When applying subsequent coats allow to dry for a minimum of 4-6 hours before recoating. If damp conditions should occur before completely dry, water marking may temporarily occur. This is quite normal and should be allowed to dry up naturally.

Reseal can after use. Clean up any spills immediately with water and household detergent while still wet. After use remove as much product as possible from brushes before cleaning with water. Do not store or use in extremes of temperature and protect from frost.

Always read the pack instructions carefully before use.