Cuprinol Fence Sprayer

Usage guide

The Cuprinol Fence Sprayer has been specially developed for use with Cuprinol One Coat Sprayable Fence Treatment. Breakthrough technology allows you to spray accurately and evenly with minimal effort to achieve a professional finish in just one coat. The sprayer allows you to reach all the awkward spaces without the need for a brush. Sprayable One Coat Fence Treatment is quick drying, pleasant to use and is safe for use near plants and pets and when you've finished simply flush the sprayer through with water.

How to apply

For best results stand with the sprayer nozzle approximately 30cm (12") from the fence panel and spray one panel at a time. Start by spraying the edges and any vertical struts before spraying the centre of the fence panel. Using a slow, sweeping motion, spray horizontally across the panel, turning at the end and overlapping approximately half of the previous pass each time. This should ensure that you achieve an even finish.

As with any sprayer it may take a couple of minutes to perfect your technique. Vary the distance of the nozzle from the fence until you get the best finish. Begin slowly and increase the pace as you get used to spraying. Take care not to spray too quickly as this may result in an uneven finish. Similarly, spraying too slowly will result in excess product being applied causing runs. Should this happen simply brush into the wood. The Cuprinol Fence Sprayer has a very controlled spray pattern, however, as with any spray product a limited amount of overspray will be created. This can be minimised by avoiding spraying in windy conditions and by using cardboard or plastic as a shield. Any overspray should be cleaned up with water and household detergent if necessary.

Excessive spillage on plants should be rinsed off before drying

Cleaning and storage

Fill the sprayer with water and reseal.

Shake the sprayer to remove Fence Treatment from round the insides and then repressurise. Do not dispose of washings into drains or watercourses. Spray water into an empty container and then flush down a sink. Repeat until the waste water runs clear. To ensure that the smaller components have been cleaned thoroughly we recommend that you clean the filters and the seal under running water using a hard bristle brush if necessary. Ensure that all parts of the trigger mechanism are also washed clean of any Fence Treatment. Ensure that liquid is completely drained from the sprayer and hose for storage. It is best to detach the hose from the sprayer tank and handset during storage.

Other information

The Cuprinol Fence Sprayer is designed for sole use with Cuprinol One Coat Sprayable Fence Treatment. Using an alternative sprayer for application will give disappointing results.

Always read the pack instructions carefully before use.